Blamsoft VK-1 Viking Uživatelský manuál stáhnout pdf (Strana 23)

CV Inputs

The CV Inputs allow Viking to be controlled by other devices in the rack. CV inputs generally

affect a current internal level by subtracting when they are negative and adding when they are

positive.

Performance

Gate – This signal triggers the envelopes

Note – The MIDI note to be played

Pitch – Controls the Pitch Wheel level

Mod – Controls the Mod Wheel level

Press – Controls the aftertouch/pressure level

Sust – Sutain Pedal Input

Modulation

Mod 1 – This signal can be selected as a source for the Mod Wheel bus

Mod 2 – This signal can be selected as a source for the On bus

Filters

Cutoff – Controls the cutoff frequency

Resonance – Controls the resonance amount for the filters

LFO

Rate – Adjusts the rate of the LFO with respect to the current rate

Sync – A digital signal that on a rising edge causes the LFO waveform to reset

S+H – A signal that will be used instead of noise for the LFO Sample and Hold circuit

Trig – A signal that will be used instead of the LFO for triggering the Sample and Hold circuit

OSC Wave

OSC1, 2, 3 – Adjusts the waveform setting for each oscillator. See Wave knob.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Žádné komentáře

Blamsoft VK-1 Viking Uživatelský manuál Strana 23